- Manufacturer Part Number: BE600M1-LM
- Plug/Connector Type: NEMA 5-15P
- Receptacle Type: NEMA 5-15R
- Receptacle Detail: 7 x NEMA 5-15R
- Number of Battery & Surge Outlets: 7
- Transfer Time: 10 ms
- Application/Usage:
- Computer
- Gaming Console
- Network
- Electronic Device
- Load Capacity: 600 VA/330 W
- Input Voltage: 120 V AC
- Input Voltage Range: 92 V AC – 139 V AC
- Output Voltage: 120 V AC
- Waveform Type: Stepped Sine Wave
- Battery Chemistry: Lead Acid
- Hot Swappable: Yes
- Typical Battery Recharge Time: 10 Hour
- Height: 5.5″
- Width: 10.8″
- Depth: 4.1″
- Form Factor: Tower
- Weight (Approximate): 7.69 lb
- Package Contents:
- Back-UPS ES 600VA, 120V,1 USB Charging Port
- User manual
- Energy Star: Yes
- Environmentally Friendly: Yes
- Limited Warranty: 3 Year
Package Contents
Overview
Turn On the Back-UPS
Press the POWER button located on the top of the Back-UPS. The POWER button will illuminate green and a single short beep will indicate that the Back-UPS is on and providing protection for connected equipment.
The Back-UPS battery charges fully during the first 24 hours while connected to AC power. The Back-UPS battery will charge regardless of whether the Back-UPS is switched on or off as long as it is connected to AC power. The UPS will have full runtime capability after the initial 24 hour charging period.
If the red Building Wiring Fault indicator (located on the end near the power cord) is lit, your building wiring may present a shock hazard that should be corrected by a qualified electrician.
Turn Off the Back-UPS
To turn off the Back-UPS, press the POWER button for at least 2 seconds. At the first beep, release the button and the UPS will turn off. A 2 second delay has been added to mitigate unintentional contact with the POWER button.
Quick Mute
The Back-UPS is able to temporarily mute user correctable alarms such as: On Battery, Battery disconnected and Overload.
During such alarms, a short press (less than 2 seconds) of the POWER button will temporarily mute the alarm until the condition has been reset. A short double beep will confirm that Quick Mute has been activated. Pressing the POWER button for more than 2 seconds will turn off the UPS.
Other critical events such as Battery replacement and Charger notification can not be temporarily muted. The unit in these cases must be turned off.
On Battery Indicator Modes
This Back-UPS has 3 On Battery Indicator modes provided that the UPS is turned on. To configure an On Battery Indicator mode, hold down the POWER button and wait for the third beep. At the third beep the POWER button will cycle red / green. Release the POWER button and its color will indicate the mode the UPS is in. Press the POWER button to cycle through each mode. See the table below for the mode selection colors. Once the mode has been selected, wait 5 seconds and the setting will be committed to the UPS.
Reviews
There are no reviews yet.